2014 Dodge Avenger Wont Start But Has Powermanage Page 2008 Fuse Box Diagram
I have a 2014 dodge avenger and it won’t crank. If you have a battery post that looks like this, it may. Does your dodge avenger have lights that come on and a clicking noise when you turn the key, but it won’t start?
Car won't start Dodge Avenger Forum
Here are the most common reasons why the dodge avenger won’t start when the engine is not cranking. Did you try jump starting the car? Look for any corrosion or damage that would cause a short or open circuit.
It will think its in.
I put in a code reader no codes popped up. I have power, wont crant or turn over, when i finally get it on i have to start it in (n) nuetral, but found out it was something tied to my brake light switch under the dash. I her a click noise and it won’t start. Send yours out to be.
If nothing happens it could be the ignition switch. If this all checks out ok i would suspect that you might have a faulty pcm control module. This article is meant to help you diagnose this exact scenario. I'm not certain of the procedure to deactivate it, but sounds like the anti theft system was activated by the work you were doing.
Car won't start Dodge Avenger Forum
Sometimes if the shifter cable is not secured.
The other day cam sensor code popped up and connector. This is an older thread, you may not. Say just replace the battery. Replace battery cables to solve dodge avenger start problems.
Dodge Avenger 2014 Family Auto of Taylors
P0128 on a 2014 Dodge Avenger with 3.6L (Thermostat Location)
20082014 Dodge Avenger Fuse Box Diagram
Dodge Avenger 2014 Family Auto of Taylors
