International 4300 Dt466 Wont Start I Have 2002 Codes Are 12 612 14p
Egr valve may be stuck open. Have a 2003 international 4300 with the dt466, 50k miles. I'm working on a 2002 international 4300 with a dt 466e engine.
I have a 07 international 4300 DT466 is a tow truck!!! it won’t click
The truck will be driving fine and all of a sudden the truck dies and will not start. 2006 international 4300 with 466 dt (automatic) i have owned this truck for two years. The engine won't crank over at all and when i jump the starter solenoid to get it running the throttle pedal is.
You can see the whole length of.
The engine won't crank over at all and when i jump the starter solenoid to get it running the throttle pedal is. I checked all electrical at the battery and cleaned the connections. You will have to check to. The starter was originally bad so i had it rebuilt.
When you try to crank the truck the 100 amp fuse next to the fuse box under the hood blows. If the temp outside is anywhere below 55 degrees out or sits after running and cools off completely the. So does it crank and not start? Truck has been sitting most of the winter, and i have been starting it every month or so to keep things fresh.
International DT466E Won't Start without Ether after Sitting YouTube
Fuses at the battery box for ecm and idm.
All 3 times same problem: Had to bridge the 2 wires that connect to the ocp sensor and voala! Make sure terminals are not too spread and. We are having our 2006 4300 (dt466) towed for the 3rd time.
There's no click or anything from the starter. If not replace the crank position sensor located on the bell housing on the driver s side. When starting it became an issue if it. This could cause a no start.
Will Not Start My 4300 Dt466 Wont Start Even with Ether, Wouldn&...
The truck will be driving fine and all of a sudden the truck dies and will not restart.
Pull the from fender off and you will see it. See if the start circuit is part of the ecm controls. Our company bought a used 2005 international 4300 with a dt466 in it. Got a 05 4300 towed into shop cranks wont start,whats been done so far is scan for codes no codes active only 1 inactive for brake switch.check eng light self checks, all fuses.
If it cranks but not start then it could be fuel related. Fuel seems to build pressure at the bleed valve. If not, it should be a matter of tracing down voltages. If it just clicks with no crank they it could be a battery or starter issue.
2007 International 4300 truck DT466 won't start
When going from the 42 to the 39, the compatibility for the 39mt ocp sensor does not work with my truck.
Hooked up reader and i am getting about 340psi. All 3 times same problem: When cranking, do you see engine rpm moving at all? Is there a ecm connector and push button under the steering column?.
I'm working on a 2002 international 4300 with a dt 466e engine. Got an 01 int 4900 with a dt466 ht with a crank no start with no attempt to even try firing up. We are having our 2006 4300 (dt466) towed for the 3rd time.
I have 2002 international 4300 dt466. Wont start codes are 12 612_14p
I have a 07 international 4300 DT466 is a tow truck!!! it won’t click
